Usage: Telephone, Computer, Workstation, Server, Mobile phone, Laptop
Support Network: Ethernet
Certification: CE, ISO, RoHS, GS
Origin: Shenzhen, China
10Gb/s serial optical interface compliant to 802.3ae 10GBASE-ER/EW
Cooled CWDM DFB LD, APD-TIA photo-detector
Up to 80km on 9/125um SMF
SFP+ MSA package with duplex LC connector
2-wire interface for management and diagnostic monitor
SFI High Speed Electrical Interface
Very low EMI and excellent ESD protection
+3.3V single power supply
Power consumption less than 2 W
Operating case temperature: 0~+70°C
10G Storage system
Compliant to SFP+ SFF-8431 and SFF-8432
Compliant with SFF-8472 Rev 10.2
Compliant with IEEE 802.3ae 10GBASE-ZR and 10GBASE-EW
Compliant with IEC 60825-1 Class 1 laser eye safe
HSFP10-0C51XXS is Cooled CWDM DFB LD based 10Gigabit With CDR SFP+ transceiver , which is designed to transmit and receive optical data over single mode optical fiber for link length up to 80km.
The SFP+ ZR With CDR module is small form factor pluggable module for duplex optical data communications such as 10GBASE-ER/EW defined by IEEE 802.3ae. It is with the SFP+ 20-pin connector to allow hot plug capability. The transmitter input and receiver output impedance is 100 Ohms differential. Data lines are internally AC coupled. The module provides differential termination and reduce differential to common mode conversion for quality signal termination and low EMI.
The transmitter converts 10Gbit/s serial PECL or CML electrical data into serial optical data compliant with the 10GBASE-ZR standard. An open collector compatible Transmit Disable (Tx_Dis) is provided. A logic "1," or no connection on this pin will disable the laser from transmitting. A logic "0" on this pin provides normal operation. The transmitter has an internal automatic power control loop (APC) to ensure constant optical power output across supply voltage and temperature variations. An open collector compatible Transmit Fault (Tx_Fault) is provided. TX_Fault is a module output contact that when high, indicates that the module transmitter has detected a fault condition related to laser operation or safety. The TX_Fault output contact is an open drain/collector and shall be pulled up to the Vcc_Host in the host with a resistor in the range 4.7-10 kΩ. TX_Disable is a module input contact. When TX_Disable is asserted high or left open, the SFP+ module transmitter output shall be turned off. This contact shall be pulled up to VccT with a 4.7 kΩ to 10 kΩ resistor.
The receiver converts 10Gbit/s serial optical data into serial PECL/CML electrical data. An open collector compatible Loss of Signal is provided. Rx_LOS when high indicates an optical signal level below that specified in the relevant standard. The Rx_LOS contact is an open drain/collector output and shall be pulled up to Vcc_Host in the host with a resistor in the range 4.7-10 kΩ, or with an active termination. Power supply filtering is recommended for both the transmitter and receiver. The Rx_LOS signal is intended as a preliminary indication to the system in which the SFP+ is installed that the received signal strength is below the specified range. Such an indication typically points to non-installed cables, broken cables, or a disabled, failing or a powered off transmitter at the far end of the cable.